Numerous course of study is amounted to | The treatment of carbon fiber milling cutter parameter

Milling cutter, it is to be used at what milling machines, have one or more tooth rotate cutting tool, and the cutting tool that carbon fiber milling cutter uses composite material of treatment carbon fiber namely. So what does the treatment parameter of carbon fiber milling cutter have? Numerous course of study is amounted to below small make up will fall for everybody introduction.

The treatment parameter of carbon fiber milling cutter:

One, cutting speed

Cutting speed is the speed that shows cutting tool contacts workpiece when cutting, express normally with M/min. When carbon fiber milling is machined, because carbon fiber is material of a kind of brittleness, should reduce cutting tool and the rate that workpiece contacts as far as possible so, lest appear,edge of burr, wool reachs the issue such as warp. Show according to the experiment, the optimal cutting speed when carbon fiber mill is machined is 400-600m/min, unfavorable and exorbitant or too low, lest affect treatment result.

2, feed speed

Feed speed is to point to the rate that increases workpiece to move along feed direction inside unit time, express with Mm/min or Mm/rev normally. When carbon fiber milling is machined, should according to the material of workpiece qualitative, hardness and the quality that machine the surface ask to wait for an element to consider integratedly, choose proper feed career. Generally speaking, high speed feed can improve treatment efficiency, but bigger to the quality influence of workpiece surface, although low speed feed machines efficiency inferior, but the quality of workpiece surface is better. The proposal feed speed of milling cutter of general carbon fiber is 100-150mm/min.

3, cutting deepness

Cutting deepness is to show milling cutter is in the deepness that cuts when cut every time. When carbon fiber milling is machined, should according to the material of workpiece the element such as the dimension of qualitative, hardness and milling cutter considers integratedly, choose proper cutting deepness. Generally speaking, cutting deepness is smaller, the working load of milling cutter is smaller, the quality that machines the surface is better also. The cutting deepness of milling cutter of proposal carbon fiber is 1-2mm.

4, cutting angle

Cutting angle is to point to the included angle between milling cutter razor blade and workpiece surface, use negative cutting part when treatment commonly, with reducing workpiece surface burr is mixed the phenomenon that break towing tie, assure the flatness of milling face and precision at the same time. The negative cutting horn of the proposal is - 5 ° come - 7 ° .

Above shares here for everybody about the treatment parameter of carbon fiber milling cutter, hope this article is helped somewhat to everybody. If still have other want to understand about the problem of carbon fiber milling cutter, can pay close attention to numerous course of study to amount to or give small make up leave a message, we expect to be discussed together with you!